Article ID: 92789
Article Last Modified on 10/28/1999
APPLIES TO
- Microsoft Windows for Workgroups 3.1
This article was previously published under Q92789
SUMMARY
Windows for Workgroups does not detect the direct memory access (DMA) channel used by the Etherlink Plus card. To set up the DMA channel for Etherlink, use the Windows Control Panel to manually set the DMA channel during or after installation.
MORE INFORMATION
By default, the Windows for Workgroups Setup program sets the DMA to channel 1, which is the factory default for this card. However, since 3Com recommends DMA channels 5, 6, or 7 for a 16-bit slot (the most common) this setting may not be correct for your card. Therefore, if you have the Etherlink Plus card in a 16-bit slot and have changed your DMA channel to 5, 6, or 7, you must run Control Panel and adjust the DMA Channel setting.
Additional query words: 3.10
Keywords: KB92789