Article ID: 57797
Article Last Modified on 8/16/2005
APPLIES TO
- Microsoft BASIC Professional Development System 7.1
- Microsoft BASIC Professional Development System 7.0
This article was previously published under Q57797
SUMMARY
Microsoft Basic Professional Development System (PDS) versions 7.0 and 7.1 have not been fully tested under and are not guaranteed to run under any version of Novell NetWare. Below are some confirmed and unconfirmed cases of problems using Basic PDS versions 7.0 and 7.1 programs with Novell NetWare.
Also, a customer has reported a problem using Basic 7.0 or 7.1 with 10-Net, a network sold by Digital Communications Associates (DCA). The customer could not open a Basic 7.0 or 7.1 ISAM database on a network drive; the error message "File already open" was returned. Microsoft has not confirmed this report.
MORE INFORMATION
Confirmed QBX.EXE Hanging Report
- Microsoft Technical Support performed one test that showed that the QBX.EXE editor may hang under Novell Advanced NetWare version 2.15 revision C. This test was performed on an IBM AT with a 16-bit Ungermann Bass network card. The test was run on a nondedicated Novell server. The QBX.EXE editor screen comes up, but at this point, the machine hangs and requires a cold reboot.
This information applies to the QBX.EXE editor that comes with Microsoft Basic PDS version 7.0 for MS-DOS.
Unconfirmed QBX.EXE Hanging Reports
- A customer reported that the QBX.EXE editor can hang under the following configuration:
When the customer booted without the Novell drivers, or with the Novell drivers and without the Microsoft Mouse 7.0 driver, QBX.EXE worked correctly without hanging. Microsoft has not confirmed this information.
COMPAQ 386/20 or ALR 386/33 computer
Version 2.15 Novell Advanced NetWare
Micom Interland board NI52100TP-8
Microsoft Mouse driver version 7.0
- A customer reported that the QBX.EXE editor can hang under the following configuration:
IBM PS/2 Model 50z computer
Version 2.15 revision C Novell SFT network
- A customer reported that if both EMM386 and the version 2.2 Novell Netware were installed, the QBX.EXE editor hangs when you try to enter a second time and you are using the following configuration:
When the customer removed either EMM386 or the Novell Netware, the QBX.EXE environment worked correctly.
AST 386SX computer
Tiara LandCard
Version 2.2 Novell NetWare
EMM386
- A customer reported that a Basic PDS 7.0 program using the OPEN COM statement may hang on a workstation connected to Novell Advanced NetWare version 2.15 revision A. When a Quarterdeck QEMM version 5.0 expanded memory driver was installed, the machine did not hang, but instead, QEMM returned an "Exception 12" error. When the software for the Novell network was removed, the computer did not hang, nor did it generate an Exception 12 error with the QEMM driver loaded. Microsoft has not confirmed this problem. The customer reported the problem on the following configuration:
Dell System 310
Novell Advanced NetWare version 2.15 revision A
MS-DOS version 3.3
80387 math coprocessor
4 MB extended memory
Video Seven VGA video card
Phoenix 80386 ROM BIOS Plus version 1.1 A05
Western Digital EtherCard Plus 16, or 3Com EtherLink card - A customer reported an "Exception 12" error message after typing QBX at the command prompt when running the following software
QEMM 6.0
Novell Advanced Netware version 2.15on the following hardware:
No error occurred when the machine was booted with a system disk.DTK keen-3332
80386 33 MHz
No math coprocessor
8 MB extended memory
DTR 386 ROM BIOS 4.26
Networth EtherNext 16bit - When Novell version 2.12 Advanced NetWare was loaded, one customer's computer hung when a Basic PDS program reached an OPEN COM statement to access the serial communications (COM1 or COM2) port. The program worked correctly when the Novell NetWare was not loaded. The customer was using MS-DOS 5.0 and a generic communications card on a Gateway 2000 386/25 MHz PC.
- A customer reported that the QBX.EXE editor hangs on the following configuration (customer did not test same program run from .EXE):
Novell NetWare 2.15 SFT revision C
Everex Step 386
Version 3 AMI BIOS
MS-DOS version 4.01 - A customer reported that QBX.EXE hangs on the following configuration (customer did not test same program run from .EXE):
Novell SFT NetWare 286 version 2.15 revision B
Unknown name AT 286
1 MB RAM
MDI graphics card (Hercules-compatible)
MF-II keyboard MS-DOS 3.3
- A customer reported that the QBX.EXE editor hangs or reboots the PC when exiting QBX.EXE 7.1 on the following configuration:
Novell NetWare 2.15 TTS
Zircom Pocket Ethernet Adapter card (for laptops)
- One customer reported that the QBX.EXE 7.1 editor hangs with network drivers loaded for Novell 386 version 3.11 with a 3Com Etherlink II Network card. Another customer reported that QBX.EXE 7.1 hangs with Novell NetWare 3.11 on a Xircom Pocket Ethernet Adapter card.
Additional query words: BasicCom 1.10 5.00 7.00 7.10
Keywords: KB57797
