Article ID: 50564
Article Last Modified on 5/12/2003
APPLIES TO
- Microsoft MS-DOS 3.1
- Microsoft MS-DOS 3.2 Standard Edition
- Microsoft MS-DOS 3.21 Standard Edition
- Microsoft MS-DOS 3.3 Standard Edition
- Microsoft MS-DOS 3.3a
- Microsoft MS-DOS 4.0 Standard Edition
- Microsoft MS-DOS 4.01 Standard Edition
- Microsoft MS-DOS 5.0 Standard Edition
- Microsoft MS-DOS 5.0a
- Microsoft MS-DOS 6.0 Standard Edition
- Microsoft MS-DOS 6.2 Standard Edition
- Microsoft MS-DOS 6.21 Standard Edition
- Microsoft MS-DOS 6.22 Standard Edition
This article was previously published under Q50564
SYMPTOMS
When a file of zero length is copied to a currently existing file, the COPY command returns the following message and incorrectly deletes the target file in the process:
CAUSE
When a file is to be copied to an existing file, the COPY command deletes the target file and then proceeds to copy the source file onto the target file. However, just before proceeding, COPY checks the length of the source file and, since it is of length zero, the COPY command is aborted. The net result is that the previously existing target file isn't undeleted and hence is lost.
WORKAROUND
You can recover the target file by using a third-party utility (such as The Norton Utilities or PC-Tools).
With MS-DOS 5.0 and later, the UNDELETE command can also be used to recover the target file.
STATUS
Microsoft has confirmed this to be a problem in the Microsoft MS-DOS packaged product versions listed at the beginning of this article. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
MORE INFORMATION
For more information on UNDELETE, query on the following words:
ms-dos and 5.00 and undelete and file
The third-party utilities mentioned above are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
Additional query words: 3.30 3.30a 4.00 4.01 5.00 5.00a 6.00 6.20 6.22
Keywords: KB50564