Microsoft KB Archive/254236

From BetaArchive Wiki
< Microsoft KB Archive
Revision as of 16:16, 18 July 2020 by 3155ffGd (talk | contribs) (importing KB archive)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Knowledge Base


Windows 2000 Server with Incoming Connections Configured Loses TCP/IP Redundancy Features

Article ID: 254236

Article Last Modified on 3/1/2007



APPLIES TO

  • Microsoft Windows Server 2003, Standard Edition (32-bit x86)
  • Microsoft Windows Server 2003, Enterprise Edition (32-bit x86)
  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server



This article was previously published under Q254236

SYMPTOMS

When you configure a Microsoft Windows 2000 Server-based computer to accept incoming calls, you cannot configure the following redundancy features of TCP/IP:

Dead Gateway Detection

Accepting ICMP Redirects from Routers


CAUSE

This behavior occurs because the Windows 2000 Server operating system enables Routing and Remote Access components when you configure an incoming connection. Routing and Remote Access components on Windows 2000 Server allow only one route to the same destination.

RESOLUTION

To resolve this issue, install the RIP Listener (Silent RIP) component if the network uses Routing Information Protocol (RIP) routing protocols to provide the server with knowledge of redundant network paths. If Microsoft Windows CE synchronization is the reason you need the incoming connection, use ActiveSync 3.0. This version does not use incoming connections and does not exhibit this behavior.


Additional query words: win2krelnotes

Keywords: kbprb KB254236