Microsoft KB Archive/253593

From BetaArchive Wiki
< Microsoft KB Archive
Revision as of 16:16, 18 July 2020 by 3155ffGd (talk | contribs) (importing KB archive)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Knowledge Base


XADM: Installation of Active Directory Connector Does Not Work Because of Logon Failure and References ID Number c007042d

Article ID: 253593

Article Last Modified on 2/27/2007



APPLIES TO

  • Microsoft Exchange 2000 Server Standard Edition



This article was previously published under Q253593


SYMPTOMS

When you install the Active Directory Connector (ADC), the Setup program tries to start the service near the end of the installation. If the service account does not have the necessary rights, Setup stops and the following error message is displayed:

The service did not start due to a logon failure.

Facility: Win32
ID no: c007042d
Microsoft Active Directory Connector Setup

CAUSE

This issue can occur if the service account does not have the necessary rights. The service account for the ADC (specified during installation) must have the right to log on as a service.

RESOLUTION

To resolve this issue, make sure that the service account has the right to log on as a service.

WORKAROUND

To work around this issue:

  1. When you receive the error message, click OK and Setup will stop.
  2. Open the Services snap-in for the member server.
  3. Find the service for the Microsoft Active Directory Connector, and then open the properties of the service.
  4. Click the Log On tab, and verify that the correct account is listed under This Account.
  5. Retype the password, and then click Apply.
  6. You should receive a message that states that the account has been given the right to log on as a service.
  7. Restart Setup for the Active Directory Connector.



Additional query words: exch2kp2w

Keywords: kberrmsg kbprb KB253593