Latest revision as of 13:51, 21 July 2020

Knowledge Base

Setver.exe Is Not Loadable in Windows Millennium Edition

Article ID: 250238

Article Last Modified on 1/27/2007

APPLIES TO

Microsoft Windows Millennium Edition

This article was previously published under Q250238

SYMPTOMS

If you run Setver.exe at a command prompt in Windows Millennium Edition (Me), you receive the following error message:

NOTE: Setver device not loaded. To activate Setver version reporting you must load the Setver.exe device in your Config.sys.

CAUSE

"Device=" entries in the Config.sys file are not processed by Windows Me. Previously installed real-mode programs are not loaded at startup with Windows Me.

STATUS

This behavior is by design.

MORE INFORMATION

This information also affects real-mode device drivers. For assistance to obtain Windows Me-compatible device drivers for a device, contact the device manufacturer.

Keywords: kberrmsg kbprb KB250238

@@ Line 56: / Line 56: @@
 == CAUSE ==
-&quot;Device=&quot; entries in the Config.sys file are not processed by Windows Me. Previously installed real-mode programs are not loaded at startup with Windows Me.
+"Device=" entries in the Config.sys file are not processed by Windows Me. Previously installed real-mode programs are not loaded at startup with Windows Me.
 </div>

Microsoft KB Archive/250238: Difference between revisions