Microsoft KB Archive/250010

From BetaArchive Wiki
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
Knowledge Base


DVDeck Does Not Capture Video After You Upgrade Compaq Presario 5670 to Windows Me

Article ID: 250010

Article Last Modified on 1/27/2007



APPLIES TO

  • Microsoft Windows Millennium Edition



This article was previously published under Q250010

If this article does not describe your hardware-related issue, please see the following Microsoft Web site to view more articles about hardware:

SYMPTOMS

When you upgrade to Microsoft Windows Millennium Edition (Me) from the factory-installed operating system on a Compaq Presario 5670, the DVDeck software does not capture video from the Institute of Electrical and Electronics Engineers (IEEE) 1394 device.

CAUSE

This behavior can occur if the factory-installed Adaptec IEEE 1394 Host Controller driver has been replaced with the Windows Me default for the device.

RESOLUTION

To resolve this issue, use the Update Device Driver Wizard to replace the Windows Me 1394 Host Controller driver with the original installed by Compaq. To do so, follow these steps:

  1. Right-click My Computer, click Properties, and then click the Device Manager tab.
  2. Select the IEEE 1394 controllers.
  3. Select the Adaptec AHA-8945CP 1394 PCI Host Adapter, and then click Properties.
  4. Click the Driver tab, and then click Update Device Driver.
  5. In the Update Device Driver Wizard, select Specify the Location of the driver, and then click Next.
  6. Select Display a list of all the drivers in a specific location, select the driver that you want, and then click Next.
  7. Click Show all hardware, click microVIDEO DV 300 IEEE-1394 Controller, and then click Next.
  8. Click Next twice more, and then click Finish.


MORE INFORMATION

When you upgrade the Compaq Presario 5670 factory-installed operating system to Windows Me, the Ohci1394 file replaces the Wn1394.vxd file.

The DVDeck software requires the Wn1394.vxd file included in the factory 1394 Host Controller driver. After the device driver has been changed to the original factory one, the 1394 Host Controller driver cannot be changed in Windows Me without first renaming the file 1394.ori to 1394.inf.

The third-party products that are discussed in this article are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, regarding the performance or reliability of these products.


Keywords: kbprb KB250010