Microsoft KB Archive/248488

From BetaArchive Wiki
< Microsoft KB Archive
Revision as of 16:14, 18 July 2020 by 3155ffGd (talk | contribs) (importing KB archive)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Knowledge Base


XCON: Event ID 9318 Occurs Within Site When Servers Operate over a WAN

Article ID: 248488

Article Last Modified on 10/28/2006



APPLIES TO

  • Microsoft Exchange Server 5.0 Standard Edition



This article was previously published under Q248488

SYMPTOMS

When you review the Event Viewer application log for Microsoft Exchange Server 5.0 Service Pack 1, you notice that the message transfer agent (MTA) is logging Event ID 9318 at random intervals. The entry is similar to the following example, though the index and Microsoft Windows NT error code numbers vary:

Event ID: 9318
Source: MSExchangeMTA
Type: Warning
Category: Interface
Description: An RPC communications error occurred. Unable to bind over RPC. The locality table (LTAB) index is 76. Windows NT error code: XXXX. [BASE IL MAIN BASE 1 500] (12)

CAUSE

This behavior can occur when you have more than one server in a site, but the servers are connected across a wide area network (WAN) rather than a local area network (LAN). Event Viewer logs this event when WAN traffic is heavy or when network connectivity is unstable.

RESOLUTION

To work around this problem, follow these steps:

  1. Open the MTA Site Configuration Properties dialog box, and then click the Messaging Defaults tab.
  2. Type 15 in the Checkpoint Size (K) box.
  3. Type 90 in the Recovery Timeout (sec) box.
  4. Type 3 in the Window Size box.

NOTE: If most of the WAN is regularly experiencing heavy traffic, this workaround may not completely alleviate the problem. It may be necessary to redesign the Exchange Server organization.

MORE INFORMATION

Checkpoints are markers for data transmission. The checkpoint size is the amount of data that is to be transferred before a checkpoint. If a transmission error occurs and the message must be transferred again, the transfer can resume from the most recent checkpoint. The default checkpoint amount is 30 kilobytes.

The recovery timeout setting is used for specifying the amount of time after a transmission error occurs that the MTA waits for a connection before deleting all checkpoints and restarting the transfer from the beginning. The default time is 60 seconds.

The window size indicates the number of checkpoints that can go unacknowledged before data transfer is suspended. The window size determines the amount of resources that are set aside for the receiving station. It is only useful to set a window size when the checkpoint size is set to something greater than zero. The default window size is 5.

Keywords: kbprb KB248488