Article ID: 247912
Article Last Modified on 1/11/2001
APPLIES TO
- Microsoft Visual Basic 6.0 Professional Edition
- Microsoft Visual Basic 6.0 Enterprise Edition
This article was previously published under Q247912
SYMPTOMS
When trying to set the DataSource or RowSource properties of the DataList or DataCombo controls in a project that also contains the Crystal Reports Smart Viewer control, you may see one or all of the following symptoms:
- The entire property page of the control goes blank.
- Visual Basic stops responding and requires you to end the task.
- You may receive the following error:
NOTE: The exact memory locations may vary from system to system.
Although these symptoms have been verified only with the DataList and DataCombo controls, the problem can occur with any data-aware control.
RESOLUTION
According to Seagate Technical Support, to work around this, remove the Smart Viewer Control from the project when you need to edit the DataSource or RowSource properties of any data-aware control that causes the symptoms listed above. After the properties have been edited, add the Smart Viewer Control back into the project.
STATUS
Microsoft provides third-party contact information to help you find technical support. This contact information may change without notice. Microsoft does not guarantee the accuracy of this third-party contact information.
For more information regarding this issue, please call Seagate Software at:
1-604-669-8379 Technical Support
1-800-877-2340 General Information
Additional query words: hang crash exception
Keywords: kbprb kb3rdparty KB247912
