Article ID: 240427
Article Last Modified on 10/30/2006
APPLIES TO
- Microsoft Windows 2000 Server
- Microsoft Windows 2000 Advanced Server
This article was previously published under Q240427
IN THIS TASK
- Upgrading to RC2
- Checking the Schema Version
- Causing a Domain Controller to Join an Earlier-Build Domain
SUMMARY
Microsoft supports upgrading Windows 2000 servers running versions later than RC1 rather than requiring a clean installation. Upgrading to later builds requires one or more schema changes that have been made to these builds. This article describes how to check the schema version, how to perform the operating system upgrade, and how to perform the schema upgrade.
back to the top
Upgrading to RC2
Assume that you have RC2 build 2128 installed on all servers in the forest and that you want to upgrade to the retail version (this procedure applies if you are upgrading from Beta 3 to RC1 as well):
- On any domain controller (preferably a domain controller in the parent domain), insert the CD-ROM of the new build and select the Upgrade option (run Winnt32.exe from the CD-ROM). You then receive a message indicating that a schema mismatch has been detected.
- Quit the upgrade process and open a command prompt window. Go to the %SystemRoot%\System32 folder and run Schupgr.exe. You see a "bind" notice and the current schema version, and then the schema is upgraded.
- When the schema upgrade process is finished, run the new build upgrade again.
- You need to perform the schema upgrade on only one computer. Replication updates it on all the other domain controllers in the forest.
NOTE: You must allow for both intersite and intrasite replication to finish sending out the schema updates. By default, intrasite replication takes place every five minutes. Intersite replication needs to be scheduled.
- Once the schema is upgraded on all the domain controllers (by replication), you can upgrade them to later builds. You can install different builds in the same forest as long as the schema is the highest schema version used by the builds.
Checking the Schema Version
You can check the schema version in either of two ways:
- Simply run Schupgr.exe on the computer you want to check. You may receive an error message, but the third line does report the version number. If the schema is already upgraded, you are informed of that fact.
- Use Registry Editor (Regedt32.exe) to view the following key:
The last parameter is the schema version number. Double-click the value to convert it to decimal. Note that Beta 3 is schema version 10, RC1 is version 11, RC2 is version 12, and retail is version 13.
HKey_Local_Machine\system\CurrentControlSet\services\NTDS\Parameters
Causing a Domain Controller to Join an Earlier-Build Domain
- Upgrade one existing domain controller in the domain/forest to the later build. This allows the schema upgrade as noted above. If you simply try to join the older-schema domain, you receive an error message stating that it is not allowed due to the schema change. This does not copy the files; you must use the upgrade process to copy the schema files.
- Let the replication process replicate the schema change on all domain controllers.
- Verify the schema version upgrade using one of the methods described above.
- Bring the new domain controller or server into the domain by using Install or Dcpromo.
Keywords: kbenv kbhowto kbhowtomaster kbsetup KB240427
