Article ID: 209265
Article Last Modified on 6/17/2005
APPLIES TO
- Microsoft Word 2000 Standard Edition
This article was previously published under Q209265
SYMPTOMS
When you try to record a macro using the Previous Row or Next Row buttons (in the Table Cell Height And Width dialog box), you do not receive the results you expect when you play back the macro.
CAUSE
This problem occurs when either of the following conditions is true when you record the macro:
- The macro was recorded using the Previous Row command, and the insertion point was in the first row of the table.
- The macro was recorded using the Next Row command, and the insertion point was in the last row of the table.
When you run the recorded macro, it does not wrap to the beginning or end of the table as it does when you perform these actions manually.
WORKAROUND
Microsoft provides programming examples for illustration only, without warranty either expressed or implied. This includes, but is not limited to, the implied warranties of merchantability or fitness for a particular purpose. This article assumes that you are familiar with the programming language that is being demonstrated and with the tools that are used to create and to debug procedures. Microsoft support engineers can help explain the functionality of a particular procedure, but they will not modify these examples to provide added functionality or construct procedures to meet your specific requirements.
To work around this problem, edit the recorded macro.
In Visual Basic for Applications, there are several methods that can be used to move the insertion point. Shown below are suggested methods that can be used to effectively wrap the insertion point to the first or last row of the current table in a document.
Using the Previous Row Command
Look for the following command line if you recorded a macro that uses the Previous Row command:
Selection.Move Unit:=wdRow, Count:=-1
Change the command line to the following:
' Make sure the insertion point is within a table. If Selection.Information(wdWithInTable) Then ' If at top of table, If Selection.Rows(1).Index = 1 Then ' Wrap to bottom of table. Selection.Move Unit:=wdRow, Count:=Selection.Tables(1).Rows.Count Else ' Otherwise, move up one row. Selection.Move Unit:=wdRow, Count:=-1 End If End If
Using the Next Row Command
Look for the following command line if you recorded a macro that uses the Next Row command:
Selection.Move Unit:=wdRow, Count:=1
Change the command line to the following:
' Make sure the insertion point is within a table. If Selection.Information(wdWithInTable) Then ' If at bottom of table, If Selection.Rows(1).Index = Selection.Tables(1).Rows.Count Then ' Wrap to top of table. Selection.StartOf wdTable, wdMove Else ' Otherwise, move down one row. Selection.Move Unit:=wdRow, Count:=1 End If End If
STATUS
Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
MORE INFORMATION
For more information about how to use the sample code in this article, click the article number below to view the article in the Microsoft Knowledge Base:
212536 OFF2000: How to Run Sample Code from Knowledge Base Articles
REFERENCES
For more information about getting help with Visual Basic for Applications, please see the following article in the Microsoft Knowledge Base:
226118 OFF2000: Programming Resources for Visual Basic for Applications
Additional query words: vb vba vbe
Keywords: kbbug kbmacroexample kbdtacode kbpending KB209265