Article ID: 201655
Article Last Modified on 1/23/2007
APPLIES TO
- Microsoft Windows 98 Standard Edition
- Microsoft Windows 98 Second Edition
This article was previously published under Q201655
SYMPTOMS
When you start your computer, you may receive the following error message:
When you restart your computer, you may receive the error message again.
CAUSE
This behavior can occur if the registry backup file you are trying to restore is damaged, or if the "damage" flag in the currently used registry file is not being reset by the Registry Checker tool.
RESOLUTION
To resolve this issue, run the Registry Checker tool using the /fix and /opt command-line switches. To do so, follow these steps:
- Restart your computer, press and hold down the CTRL key until the Windows 98 Startup menu appears, and then choose Command prompt only.
- At the command prompt, type scanreg /fix, and then press ENTER.
NOTE: The /fix command-line switch causes the Registry Checker tool to repair any damaged portions of the registry.
- After the Registry Checker tool finishes repairing the registry, press ENTER.
- At the command prompt, type scanreg /opt, and then press ENTER.
NOTE: The /opt command-line switch causes the Registry Checker tool to optimize the registry by removing unused space.
- Restart your computer.
If the behavior persists, attempt to restore a different registry backup file using the /restore command-line switch, or see the following article in the Microsoft Knowledge Base:
186909 Registry Checker Continues to Detect Registry Damage
MORE INFORMATION
For additional information about using the Registry Checker tool, please see the following articles in the Microsoft Knowledge Base:
Additional query words: w98hemjul
Keywords: kberrmsg kbfaq kbprb KB201655
