Microsoft KB Archive/193598

From BetaArchive Wiki
Knowledge Base


IP Conflict After Installing Windows NT Load Balancing Service

Article ID: 193598

Article Last Modified on 10/31/2006



APPLIES TO

  • Microsoft Windows NT Server 4.0 Standard Edition
  • Microsoft Windows NT Load Balancing Service



This article was previously published under Q193598

SYMPTOMS

After installing Windows NT Load Balancing Service (WLBS) and restarting a cluster host, the following Windows NT system error is received:

The system has detected an IP address conflict with another system on the network.

CAUSE

Probable causes are as follows:

  1. Two different cluster primary IP addresses were entered in the TCP/IP configuration in the Windows NT Network dialog box on different hosts.
  2. Two different cluster network addresses were entered in the WLBS Setup dialog box on different hosts.
  3. One or more of the cluster network interface cards (NICs) could not change its network address. This problem only occurs when using a unicast network address (instead of a multicast address).


RESOLUTION

To resolve these issues, use the corresponding resolutions below:

  1. Be sure to use one primary cluster IP address for all cluster hosts.
  2. Be sure to use one cluster network address for all cluster hosts.
  3. You should either switch to a different type of NIC or use WLBS's multicast support.



Additional query words: Convoy WLBS

Keywords: kbnetwork kbprb KB193598