Article ID: 188700
Article Last Modified on 2/27/2007
APPLIES TO
- Microsoft Windows 2000 Advanced Server
- Microsoft Windows 2000 Datacenter Server
- Microsoft Windows 2000 Server
- Microsoft Windows NT Server 4.0, Terminal Server Edition
- Microsoft Windows NT Workstation 4.0 Developer Edition
- Microsoft Windows NT Server 4.0 Standard Edition
- Microsoft Windows NT Server 4.0 Enterprise Edition
This article was previously published under Q188700
IMPORTANT: This article contains information about modifying the registry. Before you modify the registry, make sure to back it up and make sure that you understand how to restore the registry if a problem occurs. For information about how to back up, restore, and edit the registry, click the following article number to view the article in the Microsoft Knowledge Base:
256986 Description of the Microsoft Windows Registry
SYMPTOMS
If account lockout option and password protected screen saver are enabled and the user tries to get past the screen saver password unsuccessfully, it increments the account lockout counter. Numerous bad attempts should result in the domain account being locked out. The problem is that the screen saver password does not check to see if the account is locked out. So, if the account lockout counter is set to five bad attempts before locking the account, the screen saver lets the user in if a correct password is entered even after five bad attempts.
CAUSE
This is the expected behavior. To change this default behavior so that the screen saver keeps track of bad password count and locks the account once the bad password count is reached, please apply service pack 4 and the registry entry mentioned in the Resolution section.
RESOLUTION
WARNING: If you use Registry Editor incorrectly, you may cause serious problems that may require you to reinstall your operating system. Microsoft cannot guarantee that you can solve problems that result from using Registry Editor incorrectly. Use Registry Editor at your own risk.
To install the fix:
- Click Start, Run, type REGEDT32 and click OK.
- Navigate to the key HKEY_LOCAL_MACHINE\Software\Microsoft\Windows NT\CurrentVersion\Winlogon.
- If the ForceUnlockLogon value does not exist, add it. To do so click Edit, select Add Value, type ForceUnlockLogon, change Data Type to REG_DWORD and click OK. When the DWORD Editor opens, add the number 1 into the Data field and ensure Hex is selected, then click OK. The ForceUnlockLogon should appear in the right pane of the Winlogon screen.
- Close the Registry Editor.
- Restart the computer.
STATUS
Microsoft has confirmed that this is a problem in Windows NT 4.0 and Windows NT Server 4.0, Terminal Server Edition. This problem was first corrected in Windows NT 4.0 Service Pack 4.0 and Windows NT Server 4.0, Terminal Server Edition Service Pack 4.
Keywords: kbhotfixserver kbqfe kbfix kbprb kbqfe KB188700
