Article ID: 188127
Article Last Modified on 1/23/2007
APPLIES TO
- Microsoft Windows 98 Standard Edition
This article was previously published under Q188127
SUMMARY
This article describes how to create a modified Windows 98 Startup disk to gain access to hardware devices using third-party drivers not provided on the Windows 98 CD-ROM.
MORE INFORMATION
The Windows 98 Startup disk provides support for most types of CD-ROM drives, including integrated device electronics (IDE) and small computer system interface (SCSI) CD-ROM drives, but it may not support your particular CD-ROM drive or other hardware device (such as a tape drive or removable media drive). To gain access to these hardware devices when you start your computer, you may need to modify the Windows 98 Startup disk. To do so, use either of the following methods:
Modify the Windows 98 Startup Disk
- Refer to the documentation included with your computer or hardware device to determine the file required for access to the device.
- Copy the file to the Windows 98 Startup disk.
- Using a text editor (such as Notepad), add a line to load the driver in the [COMMON] section of the Config.sys file on the Windows 98 Startup disk.
- Check for modifications you may need to make to the Autoexec.bat file on the Windows 98 Startup disk.
The Windows 98 Startup disk has approximately 248,832 bytes available for the additional files required to gain access to your hardware devices. If more space is required you can delete the unused device drivers copied to the disk.
For additional information about the files included on the Windows 98 Startup disk, see the following article in the Microsoft Knowledge Base:
ARTICLE-ID: 185645
TITLE : Contents of the Windows 98 Startup Disk
Modify or Add files to the Ebd Folder
You can create a modified Windows 98 Startup disk every time you run the Bootdisk.bat file by copying the required device drivers to the Windows\Command\Ebd folder, and then modifying the Config.sys and Autoexec.bat files in the Ebd folder as appropriate. All files in the Ebd folder are copied to the Windows 98 Startup disk, so make sure the folder does not contain more files than the disk can hold (approximately 1,234,432 bytes).
NOTE: Adding files to the Ebd folder does not affect the files copied to a Windows 98 Startup disk created using the Add/Remove Programs tool in Control Panel. These files are copied from the Windows 98 CD-ROM.
For information about how to create a Windows 98 Startup disk using the Add/Remove Programs tool, click Start, click Help, click the Index tab, type startup, and then double-click the "Startup Disk" topic.
For information about how to create a Windows 98 Startup disk using the Bootdisk.bat file, please see the following article in the Microsoft Knowledge Base:
ARTICLE-ID: 186300
TITLE : How to Create a Windows 98 Startup Disk from MS-DOS
For information about specific CD-ROM drives that require real-mode drivers to work in Windows, please see the following article in the Microsoft Knowledge Base:
ARTICLE-ID: 131499
TITLE : CD-ROM Drives Requiring Real-Mode Drivers
Additional query words: ebd esd
Keywords: kbenv kbhardware kbhowto KB188127
