Article ID: 182066
Article Last Modified on 9/22/2005
APPLIES TO
- Microsoft SNA Server 4.0
This article was previously published under Q182066
SYMPTOMS
An application exception occurs in Ppd5250.dll when print data from an AS/400 contains a Set Line Density (SLD) SCS control code that specifies a value of zero.
CAUSE
The 5250 print provider tries to determine line density by dividing 72 by the value specified in the SLD SCS control code. This results in a divide by zero error and an application exception in Ppd5250.dll if the SLD control code specifies a value of zero.
STATUS
Microsoft has confirmed this to be a problem in SNA Server version 4.0. This problem was corrected in the latest SNA Server version 4.0 U.S. Service Pack. For information on obtaining this Service Pack, query on the following word in the Microsoft Knowledge Base (without the spaces):
S E R V P A C K
MORE INFORMATION
The Set Line Density SCS control code is used to set the numbers of lines per inch for a print job. The SLD control code has the following format:
Set Line Density (SLD) - '0x2BC6[L](Point)'
Parameter: [L] - length, including length byte. Value of '0x01'
denotes default
Point - Distance to be moved vertically for a single line.
The number is indicated in typographic points (one point is
equal to 1/72 inch). Setting a value of '0x0C' will result
in 6 lines per inch, a value of '0x09' will result in 8
lines per inch. Value of '0x00' denotes default a value of
6 lines per inch.
Example: 2BC6020C
The 5250 print provider has been updated so that an SLD with a value of zero is correctly interpreted to indicate a default line density of six lines per inch instead of causing the divide by zero error.
Keywords: kbbug kbfix kbqfe kbhotfixserver KB182066
