Microsoft KB Archive/172552: Difference between revisions

From BetaArchive Wiki
(importing KB archive)
 
m (Text replacement - ">" to ">")
Line 33: Line 33:
# Click Start, point to Settings, and then click Control Panel.
# Click Start, point to Settings, and then click Control Panel.
# Double-click Network.
# Double-click Network.
# On the Configuration tab, click either TCP/IP (if you do not have a network adapter) or "TCP/IP -> Dial-Up Adapter" (if you do have a network adapter), and then click Properties.
# On the Configuration tab, click either TCP/IP (if you do not have a network adapter) or "TCP/IP -> Dial-Up Adapter" (if you do have a network adapter), and then click Properties.
# On the IP Address tab, click Obtain An IP Address Automatically.
# On the IP Address tab, click Obtain An IP Address Automatically.
# On the DNS Configuration tab, click Disable DNS.
# On the DNS Configuration tab, click Disable DNS.

Revision as of 19:55, 20 July 2020

How to Configure TCP/IP for The Microsoft Network

Q172552



The information in this article applies to:


  • The Microsoft Network versions 2.0, 2.5, 5.0, 5.1





SUMMARY

Transmission Control Protocol/Internet Protocol (TCP/IP) is the network protocol used by MSN, The Microsoft Network. This article describes how to configure TCP/IP for MSN.



MORE INFORMATION

To configure TCP/IP for MSN, follow these steps:

  1. Click Start, point to Settings, and then click Control Panel.
  2. Double-click Network.
  3. On the Configuration tab, click either TCP/IP (if you do not have a network adapter) or "TCP/IP -> Dial-Up Adapter" (if you do have a network adapter), and then click Properties.
  4. On the IP Address tab, click Obtain An IP Address Automatically.
  5. On the DNS Configuration tab, click Disable DNS.
  6. On the WINS Configuration tab, click Disable WINS Resolution.
  7. On the Gateway tab, make sure the Installed Gateways box is empty. If any gateways are listed in this box, click a gateway and then click Remove. Repeat this step until the Installed Gateways box is empty.
  8. On the Bindings tab, make sure no network components are selected. If any network component is selected, click the check box to the left of the component to clear it. If you are prompted to choose a driver to bind with, click No.
  9. Click OK. If you are prompted to restart the computer, click Yes.

Additional query words:

Keywords : kbnetwork
Issue type : kbhowto
Technology : kbMSNSearch kbMSN510 kbMSN500 kbMSN200 kbMSN250


Last Reviewed: June 30, 2000
© 2001 Microsoft Corporation. All rights reserved. Terms of Use.