Microsoft Knowledge Base
PRB: White Spots Appear on Textures
Last reviewed: July 11, 1997
Article ID: Q171242
The information in this article applies to:
- Softimage 3D for IRIX, version 3.7
SYMPTOMS
White spots appear on your textures.
CAUSE
This occurs because patch #1918 is missing. Patch #1918 is an SGI patch that is required to run SOFTIMAGE 3D.
RESOLUTION
Contact SGI and request and install patch #1918.
REFERENCES
If you have any questions concerning the information contained in this article, contact support@softimage.com by e-mail.
Keywords : kbgraphic kbhw kbtshoot si si3d si3dhard si3dmat
Version : 3.7
Platform : IRIX
Issue type : kbprb
THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.
Last reviewed: July 11, 1997
©1997 Microsoft Corporation. All rights reserved. Legal Notices.
|
