Article ID: 169478
Article Last Modified on 2/26/2007
APPLIES TO
- Microsoft Windows 2000 Server
- Microsoft Windows 2000 Advanced Server
- Microsoft Windows 2000 Professional Edition
- Microsoft Windows NT Server 4.0 Standard Edition
- Microsoft Windows NT Workstation 4.0 Developer Edition
This article was previously published under Q169478
SYMPTOMS
When you connect to a Remote Access Service (RAS) server from a Windows NT RAS client using the automatic dialing feature to access a remote network resource, there may be a long pause of approximately two minutes while the dial-up connection is being established. During that time, the connection dialog box displays the following message:
Registering your computer on the network...
Eventually, you may receive an error message similar to the following:
CAUSE
RAS is timing out before an IP address can be obtained or confirmed.
RESOLUTION
To resolve this issue, use any of the following methods:
Method 1
After you receive the error message, you are still connected to the RAS server. Cancel the first attempt, and then try to access the network resource again.
Method 2
Use a protocol other than TCP/IP for your dial-up connection (such as the NetBEUI or IPX/SPX-compatible protocol). You can enable the NetBEUI or IPX/SPX-compatible protocol and disable TCP/IP in the phone book entry properties in Dial-Up Networking (DUN). Note that these protocols must be installed for RAS and DUN to use them. You can install these protocols using the Network tool in Control Panel.
Normally, Windows NT RAS servers act as NetBIOS gateways for the network to which they are attached. Therefore, a RAS client dialing in with only, for example, the NetBEUI protocol can see all Windows NT resources running TCP/IP (assuming the RAS server is configured to use both protocols).
For additional information about the NetBIOS gateway feature of the Windows NT RAS server, see the following Internet web site:
Method 3
Do not use the automatic dialing feature. Connect to the remote network using RAS (using the DUN phone book entry) before trying to access the remote server.
STATUS
Microsoft has confirmed this to be a problem in Microsoft Windows NT version 4.0. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
Additional query words: hang
Keywords: kbnetwork KB169478
