Article ID: 159484
Article Last Modified on 1/19/2007
APPLIES TO
- Microsoft Word 97 Standard Edition
This article was previously published under Q159484
SUMMARY
In Microsoft Visual Basic for Applications, there is no built-in command to allow pausing macro execution. This article contains a Visual Basic for Applications routine to simulate pausing a macro.
MORE INFORMATION
Microsoft provides programming examples for illustration only, without warranty either expressed or implied, including, but not limited to, the implied warranties of merchantability and/or fitness for a particular purpose. This article assumes that you are familiar with the programming language being demonstrated and the tools used to create and debug procedures. Microsoft support professionals can help explain the functionality of a particular procedure, but they will not modify these examples to provide added functionality or construct procedures to meet your specific needs. If you have limited programming experience, you may want to contact a Microsoft Certified Partner or the Microsoft fee-based consulting line at (800) 936-5200. For more information about Microsoft Certified Partners, please visit the following Microsoft Web site:
For more information about the support options that are available and about how to contact Microsoft, visit the following Microsoft Web site:
For more information about how to use the sample code in this article, click the article number below to view the article in the Microsoft Knowledge Base:
173707 OFF97: How to Run Sample Code from Knowledge Base Articles
You can simulate a pause in Visual Basic for Applications by using the following macro example. When the macro runs, it checks to see whether there is a command assigned to a specified keystroke. If there is no command assigned, the macro assigns itself as the command. When the key combination is used in a Word document, this macro example resumes running and, at the same time, disables the key assignment made previously.
NOTE: Replace the key constants in this example with the key combination that you want to use.
Sub MacroPauseExample()
Dim mykey As Variant
'Set the Normal.dot to hold keyboard changes.
CustomizationContext = NormalTemplate
' Determine Pause State by looking at the
' specified key combination command assignment.
Set mykey = KeyBindings.Key(BuildKeyCode _
(wdKeyControl, wdKeyAlt, wdKeyA))
' If there is no Command assignment(meaning
' the macro is not in a paused state).
If (mykey Is Nothing) Then
' ------------------------------------------------------
' <Place your code to run, BEFORE the pause occurs, here.>
' ------------------------------------------------------
' Pause the macro.
KeyBindings.Add KeyCode:=BuildKeyCode _
(wdKeyControl, wdKeyAlt, wdKeyA), _
KeyCategory:=wdKeyCategoryMacro, Command:="MacroPauseExample"
Exit Sub
Else ' The macro has been paused. Clear the pause state.
' Sets the Normal.dot to hold keyboard changes.
CustomizationContext = NormalTemplate
' Clear Pause State.(Clear the command associated
' with the specified key combination.)
FindKey(BuildKeyCode(wdKeyControl, wdKeyAlt, wdKeyA)).Clear
End If
' ------------------------------------------------------------
' <Place your code to run, AFTER the pause is complete, here.>
' ------------------------------------------------------------
End Sub
For additional information about available resources for creating custom solutions using Visual Basic for Applications and Microsoft Word 97, click the article numbers below to view the articles in the Microsoft Knowledge Base:
163425 WD97: Macro Programming Resources
163435 VBA: Programming Resources for Visual Basic for Applications
Additional query words: wordcon vb vba vbe halt stop paused pausing halting stopping
Keywords: kbdtacode kbhowto kbmacroexample kbusage KB159484
