Article ID: 156369
Article Last Modified on 10/28/2006
APPLIES TO
- Microsoft Exchange Server 4.0 Standard Edition
This article was previously published under Q156369
SYMPTOMS
It is impossible to send a message from a remote message transfer agent (MTA) to Microsoft Exchange Server over a 1988 X.400 connector. The message is rejected with a non-delivery report (NDR). In the Microsoft Exchange Server Application Event log you will see the following error message:
CAUSE
This error will occur when the remote MTA is configured to send all message content as a General Text Body Part and sends a message containing only IA5 characters. This configuration is possible with the DEC MRX product.
General Text Body Part has a parameter for designating character set registrations. Currently the Microsoft Exchange Server system sends out {C0,G0,G1} == {1,6,100} for character set ISO8859-1.
1 == C0 control characters like LF, CR and so forth
6 == ISO646 basic 7 bit characters for ASCII in G0
100 == ISO8859-1 G1 extended Latin 1 chars
Inbound, the MTA checks for the presence of 6 and 100, and if it has both, it then uses the ISO8859-1 tables to do the conversion, otherwise an NDR message is sent with invalid content type because no support for other character sets exists.
RESOLUTION
A possible workaround is to configure the remote MTA so that it does not send all messages as General Text Body Part.
This fix allows Microsoft Exchange to accept General Text Body Part with the following registered character sets {C0,G0} == {1,6}.
To resolve this problem, obtain the hotfix mentioned below.
STATUS
Microsoft has confirmed this to be a problem in Microsoft Exchange version 4.0. This problem was corrected in the latest Microsoft Exchange 4.0 U.S. Service Pack. For information on obtaining the service pack, query on the following word in the Microsoft Knowledge Base (without the spaces):
S E R V P A C K
Keywords: kb3rdparty kbbug kbfix kbusage KB156369
