Article ID: 154062
Article Last Modified on 11/1/2006
APPLIES TO
- Microsoft Windows NT Workstation 4.0 Developer Edition
- Microsoft Windows NT Server 4.0 Standard Edition
This article was previously published under Q154062
SUMMARY
This article documents how to connect to a Point-to-Point Tunneling Protocol (PPTP) enabled server across the Internet, while connecting to a non-PPTP enabled Internet service provider (ISP).
PPTP enables implementation of secure, multiprotocol Virtual Private Networks (VPNs) through public data networks such as the Internet. Through PPTP, it is possible for remote users to access their corporate networks and applications by dialing into the local ISP's Point of Presence (POP), instead of dialing directly into the company network. PPTP connects directly to the target server by creating a virtual network for each remote client, one that the Windows NT Server 4.0 administrator can monitor and manage like any other remote access port.
MORE INFORMATION
Before you make a connection, in order to use PPTP to connect to a server securely across the Internet, the PPTP protocol must be loaded. To load the PPTP protocol, do the following:
- Click Start, point to Settings, click Control Panel, and then double-click Network.
- On the Protocols tab, add PPTP.
- After the protocol is loaded, Remote Access Service (RAS) is invoked. You must add at least one VPN port as a port in the RAS setup interface.
- At this time, specify which protocols you want to run for that VPN port. You can install up to 256 VPN ports. Each VPN can be connected to a network.
- Make sure that at least one VPN is configured for dial-out. One other consideration is that you must know what protocol is used on the receiving PPTP server, and select that protocol and configure it for the VPN port.
- Re-apply the last applied service pack.
To make the connection, do the following:
- Assuming that you have a phone book entry for your ISP, create a phone book entry for the PPTP server. The actual phone number is the name of the host or an IP address. Using the IP address of the PPTP RAS server is ideal. There may be name resolution considerations otherwise. Make sure that the Dial Using dialog has a RASPPTPM VPN port assigned to it.
- Dial the ISP using the standard phone book entry created for the ISP. When you have established a connection, dial the IP address or host name of the computer.
For additional information about routing, click the article numbers below to view the articles in the Microsoft Knowledge Base:
128647 Troubleshooting TCP/IP LAN and RAS Routing Issues
140859 TCP/IP Routing Basics for Windows NT
Additional query words: prodnt sur tcpip netbeui ipx nwlink
Keywords: kbinfo kbnetwork KB154062
