Microsoft KB Archive/137966

From BetaArchive Wiki
Knowledge Base


Changing NetBIOS Name Resolution Order in Windows for Workgroups

Article ID: 137966

Article Last Modified on 8/18/2005



APPLIES TO

  • Microsoft TCP/IP-32 for Windows for Workgroups 1.0
  • Microsoft Windows for Workgroups 3.2



This article was previously published under Q137966

SUMMARY

By default, the NetBIOS name resolution mode used by NetBIOS over TCP/IP is B-node mode. If a WINS server is specified in the TCP/IP configuration, the default mode is H-node.

MORE INFORMATION

In Windows for Workgroup running TCP/IP-32, these default settings can be modified to change to NetBIOS name resolution mode to B-node, P-node, M-node, or H-node.

To change the NetBIOS name resolution order:

  1. Open the SYSTEM.INI file with a text editor.
  2. In the [NBT] section, add the following entry:

    NodeType = 1, 2, 4, or 8

    These values specify the mode of NetBIOS name resolution used by NetBIOS over TCP/IP, where:

    1 = b-node

    2 = p-node

    4 = m-node

    8 = h-node.

    NOTE: This value can also be configured via DHCP Manager on the DHCP server. Under DHCP Options, select Scope or Global. The default is 1 (b- node). If no value is specified and a WINS server is specified and its NodeType is blank, then the default is 8 (h-node). On the Windows for Workgroups client configure it to use DHCP under Control Panel, Network, highlight TCP/IP Protocol in the Installed Network Software windows and select Configure. Enter an X in the Enable Automatic DHCP Configuration box by clicking on it. Click on OK and reboot the Windows for Workgroup client.
  3. Save your changes and restart Windows.

NOTE: For more details on node type implementation refer to TCP/IP-32 online help.


Additional query words: prodtcp 3.11

Keywords: KB137966