Article ID: 124955
Article Last Modified on 10/30/2006
APPLIES TO
- Microsoft Mail Gateway to Novell Message Handling System 3.0
- Microsoft Mail Gateway to Novell Message Handling System 3.0
This article was previously published under Q124955
SUMMARY
Microsoft provides a replacement for the INSTALL.EXE file that is included with version 3.0 of Microsoft Mail Gateway to MHS and version 3.0 of Microsoft Mail Gateway to MHS Access.
For complete information about obtaining and installing the INSTALL.EXE file, see the following sections:
- To download the updated files
- To replace your INSTALL.EXE file
MORE INFORMATION
This update corrects the following problem:
- The installation procedure runs out of memory and is unsuccessful on postoffices if more than 429 postoffices are already defined in the Mail Administrator program (ADMIN.EXE).
To download the updated file
The files listed below are available to download from the Microsoft Download Center. For information on how to download these files, please see the "To download the updated files" section below.
FILES AVAILABLE FROM ONLINE SERVICES
Item ID Filename Description
-----------------------------------------------------------
S15128 MHSGINST.EXE Update for Microsoft Mail
Gateway to MHS
S15129 MHSAINST.EXE Update for Microsoft Mail
Gateway to MHS Access
To download the updated files
The following files are available for download from the Microsoft Download Center:
![[GRAPHIC: Download]](/wiki/index.php?title=File:Download.gif){kind=small}
For additional information about how to download Microsoft Support files, click the following article number to view the article in the Microsoft Knowledge Base:
119591 How to Obtain Microsoft Support Files from Online Services
Microsoft scanned this file for viruses. Microsoft used the most current virus-detection software that was available on the date that the file was posted. The file is stored on security-enhanced servers that help to prevent any unauthorized changes to the file.
After you download MHSGINST.EXE or MHSAINST.EXE to a clean directory, run it (by typing mhsginst or mhsainst, respectively, at the MS-DOS prompt) to extract the contents of the file. You should receive the following files:
MHSGINST.EXE:
INSTALL.EXE (40,233 bytes, dated 12-20-94, 8:59 A.M.)
README.TXT
MHSAINST.EXE:
INSTALL.EXE (42,345 bytes, dated 12-19-94, 1:51 P.M.)
README.TXT
To replace your INSTALL.EXE file
- At the MS-DOS command prompt, type the following and press ENTER
copy <path>:\install.exe <destination>
where <path> is the drive and directory where you ran the self extracting MHSGINST.EXE or MHSAINST.EXE file and <destination> is the drive and directory where your Gateway to MHS or Gateway to MHS Access disk currently resides. For example, if you ran the self-extracting file from the TEST directory on drive D, and your gateway disk is located in drive A, type the following commands:
copy d:\test\install.exe a:
- Follow the installation steps as outlined in the Microsoft Mail Gateway to MHS "Administrator's Guide."
Additional query words: 3.00
Keywords: kbdownload kbgraphxlinkcritical KB124955
