Article ID: 122150
Article Last Modified on 12/5/2003
APPLIES TO
- Microsoft Windows for Workgroups 3.11
- Microsoft Windows NT Advanced Server 3.1
- Microsoft Windows NT Server 3.5
- Microsoft Windows NT Workstation 3.1
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Advanced Server 3.1
This article was previously published under Q122150
SYMPTOMS
When your Windows for Workgroups 3.11 machine is configured with Novell ODI drivers, and attempts to be validated by a LAN Manager or Windows NT server, you receive the following error message:
CAUSE
This error occurs when you run NET START FULL before you start Windows for Workgroups 3.11. When you run NET START FULL with ODI drivers, Windows for Workgroups uses the IPX transport to obtain validation. Because Windows NT 3.1 does not recognize IPX/SPX (it recognizes IPX/SPX with NetBIOS), Windows NT 3.1 does not validate the client machine.
NOTE: In this case, Windows for Workgroups cannot use NetBEUI and IPX/SPX because they are protect-mode protocols and cannot be loaded from the MS-DOS command prompt.
RESOLUTION
To resolve this problem, do one of the following:
- Upgrade to Windows NT Advanced Server version 3.5. Windows NT Advanced Server 3.5 can use the IPX transport without NetBIOS.
-or-
- Load ODINSUP and NETBEUI. ODINSUP allows real-mode protocols, such as NETBEUI, to load so that the network can communicate with the Windows NT domain server through the real-mode protocol. Because Microsoft doesn't support the use of ODINSUP, this workaround has not been tested and is not supported by Microsoft.
-or-
- Load the Novell implementation of NetBIOS (NETBIOS.EXE) from the MS-DOS command prompt. This workaround has not been tested and is not supported by Microsoft.
MORE INFORMATION
The products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
Additional query words: 3.11 3rdparty net ware winnt 3.10 client validation
Keywords: KB122150
