Article ID: 108654
Article Last Modified on 9/2/1999
APPLIES TO
- Microsoft Works 3.0 Standard Edition
This article was previously published under Q108654
3.00 WINDOWS kbother
The following is a list of the default Modem Settings for the Works Communications module. To access these settings, choose Modem from the Settings menu, and choose Advanced. If your settings have been changed, you can return to the default settings by choosing the Restore button.
Commands
Initialize ATQ0V1X4E1S0=0 Dial Prefix ATDT Dial Suffix Escape +++ Hang Up ATH Answer Mode On ATQ1E0S0=1 Answer Mode Off ATQ0V1E1S0=0
Results
OK OK Acknowledges execution of a command. Error ERROR Invalid command or incorrect checksum in response to command. Busy BUSY Modem has detected a busy signal. No Carrier NO CARRIER Failure to connect or loss of carrier. Connect CONNECT Modem has connected at 300 baud. Ringing RING Ring Detected. No Dialtone NO DIALTONE The W dial modifier was issued and a dialtone was not detected within the period of time specified by S7. The X2 or X4 options are selected and a dialtone is not detected within 5 seconds of going off-hook.
Additional query words: communications comm cm
Keywords: KB108654