Article ID: 106713
Article Last Modified on 10/14/1999
APPLIES TO
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q106713
SYMPTOMS
If you are upgrading to Windows for Workgroups 3.11 on a system that is running Microsoft Workgroup Connections 1.0 and has an SMC Elite+ network adapter, the correct I/O address may not be detected for the SMC adapter.
If the SMC Elite+ network adapter is not configured to use the default 0x280h I/O address, you must select the correct setting when Setup prompts you for confirmation.
CAUSE
To determine the I/O address for the network adapter, Windows for Workgroups 3.11 Setup examines the existing PROTOCOL.INI file in use by Workgroup Connections 1.0. If the network adapter is an SMC Elite+, the I/O address is not found in the PROTOCOL.INI file. (The SMC Elite+ NDIS2 driver for use with Workgroup Connections 1.0 does not require that an I/O address be stored in the PROTOCOL.INI file.)
Since an I/O address is not found in the PROTOCOL.INI file, the default I/O address of the SMC Elite+ network adapter is selected and you are given an opportunity to confirm this selection.
Additional query words: WC 3rdparty 3.11
Keywords: KB106713