Article ID: 105502
Article Last Modified on 10/31/1999
APPLIES TO
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q105502
SYMPTOMS
If you are using Microsoft Windows for Workgroups version 3.11 with 32-bit file access enabled and you have an Intel CAS fax modem, your modem may fail to receive faxes.
CAUSE
Intel CAS fax modems require a driver called CASMGR.EXE, which can be run from the AUTOEXEC.BAT file or from the MS-DOS command prompt. This driver is responsible for communicating API calls from fax applications to the CAS modem and for sending information from the fax modem to the fax applications. When the CAS fax modem receives a fax, CASMGR.EXE spools this information to the hard disk drive. CASMGR.EXE opens the file in a virtual machine (VM) and obtains a handle. It then uses the handle to write to the file as data comes in from the fax board (often at interrupt time).
The problem occurs if a second VM is active at the same time. The second VM is using a handle that is only valid for the first VM.
NOTE: By default, Windows for Workgroups 3.11 starts a second VM to run the server; therefore, this problem is likely to occur.
WORKAROUND
To work around this problem, you can either:
- Disable 32-bit file access in Windows for Workgroups.
-or-
- Remove the CASMGR.EXE line from your AUTOEXEC.BAT file, and add it to your WINSTART.BAT file. To create a WINSTART.BAT file, use a text editor, such as Notepad, to create a file with that name; type the CASMGR.EXE line that you cut from your AUTOEXEC.BAT file into the new WINSTART.BAT file; save the WINSTART.BAT file in your Windows directory, and restart your system. WINSTART.BAT loads the CASMGR.EXE file into the system VM only, and ensures that all its file input/ output occurs from that VM.
NOTE: This workaround prevents any MS-DOS-based applications that require CASMGR.EXE from accessing the fax modem.
WARNING: If you use a WINSTART.BAT file with Microsoft Windows version 3.1 in 386 enhanced mode, the system may stop responding (hang) when you exit Windows. The only solution to this problem is to delete or rename WINSTART.BAT and load the programs in WINSTART.BAT from the AUTOEXEC.BAT file.
MORE INFORMATION
For more information on WINSTART.BAT, refer to page 531 of the Microsoft Windows "User's Guide" for version 3.1.
STATUS
Microsoft has confirmed this to be a problem in Windows for Workgroups version 3.11. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
Additional query words: wincomm 3.11 VFAT EFAX
Keywords: KB105502
