Microsoft KB Archive/105273

From BetaArchive Wiki
< Microsoft KB Archive
Revision as of 10:11, 20 July 2020 by X010 (talk | contribs) (Text replacement - """ to """)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Knowledge Base

Article ID: 105273

Article Last Modified on 11/26/1999


  • Microsoft MS-DOS 6.0 Standard Edition
  • Microsoft MS-DOS 6.2 Standard Edition
  • Microsoft MS-DOS 6.22 Standard Edition

This article was previously published under Q105273

This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames.


If your system boots using a first generation RPL chip in an IBM Token Ring card, the system may stop responding (hang).


This problem occurs due to a timing problem between the RPL chip and the MS-DOS 6 code used to pause the system during startup.


To work around this problem, upgrade to a later generation RPL chip or add the following command to your CONFIG.SYS file:


If you are using MS-DOS 6.2 and DoubleSpace, you need to add the SWITCHES=/F command to your DBLSPACE.INI file as well. To do so, type "dblspace /switches=f" (without the quotation marks) at the MS-DOS command prompt and then press ENTER.

NOTE: You need to contact the system administrator to have the CONFIG.SYS file updated in the RPL chip.


An RPL chip is inserted in an IBM Token Ring card and provides remote boot ability.

Additional query words: 6 6.00 6.20 token ring fru25f8923

Keywords: KB105273