Microsoft KB Archive/104203

From BetaArchive Wiki
Knowledge Base


Err Msg: STOP: C0000218 ...Registry Cannot Load the Hive

Article ID: 104203

Article Last Modified on 10/31/2006



APPLIES TO

  • Microsoft Windows NT Advanced Server 3.1
  • Microsoft Windows NT Workstation 3.1



This article was previously published under Q104203


SYMPTOMS

When you install Windows NT or Windows NT Advanced Server from a CD to a machine whose C drive is a SCSI drive with a DTC3290 SCSI controller, Setup may fail, displaying the STOP message:

STOP: c0000218 {Registry File Failure}
The registry cannot load the hive (file):
\SystemRoot\System32\Config\SOFTWARE
or its log or alternate.
It is corrupt, absent, or not writeable.

CAUSE

During the installation process, Windows NT expects to read certain information from the SOFTWARE registry hive. Due to a hardware problem, this cannot be done.

RESOLUTION

This problem was not reproducible at Microsoft. If you run into this problem, the following steps may help:

  • Use only hardware listed on the hardware compatibility list (HCL).
  • Ensure that the SCSI bus is properly terminated at both ends.
  • Try a different SCSI cable.
  • DTC has a firmware upgrade that fixes certain over-run problems.



Additional query words: prodnt blue trap

Keywords: kbhardware kbsetup KB104203