Microsoft KB Archive/104067

From BetaArchive Wiki
< Microsoft KB Archive
Revision as of 15:03, 18 July 2020 by 3155ffGd (talk | contribs) (importing KB archive)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Knowledge Base


Article ID: 104067

Article Last Modified on 10/30/2006



APPLIES TO

  • Microsoft Mail Gateway to X.400 3.2



This article was previously published under Q104067

SUMMARY

Version 3.2 of Microsoft Mail Gateway to X.400 allows you to use the TP0/X.25 transport, the TP4/CLNP transport, or both transports. This article describes how to set the TP0/X.25 transport in the EiconCard Redirector mode.

With this configuration, the EiconCard and OSI LAN Gateway software are both installed on an EiconCard server computer. The OSI LAN Gateway DOS Workstation software is installed on a separate computer that is used to run the X.400 gateway.

MORE INFORMATION

To use this configuration:

  1. On the EiconCard server, install the EiconCard and the OSI LAN Gateway DOS Gateway software.
  2. On the Gateway computer, install the EiconCard and the OSI LAN Gateway DOS Workstation software.
  3. On the EiconCard server, modify the AUTOEXEC.BAT file to set up the computer as an EiconCard server.
  4. On the Gateway computer, modify the AUTOEXEC.BAT file to set up the computer as an EiconCard redirector.

Example 1

The following example shows parts of the AUTOEXEC.BAT files when the gateway computer is an EiconCard redirector. X25serv is the server name, mypassword is the server password, x25redir is the redirector name, and four workstation sessions are being supported on the redirector computer by the Eicon software.

On the server (the computer with the EiconCard):

REM Starting LAN Manager
NET START ...

REM Starting X.25
NABIOS SRV x25serv mypassword /12
ECLOAD


On the redirector (the gateway computer):

REM Starting LAN Manager
NET START ...

REM Starting X.25
NABIOS RDR x25redir /4
ECUSE x25serv mypassword


Example 2

This example shows the AUTOEXEC.BAT files needed for the gateway on a Novell NetWare network. Again, four workstation sessions are being supported on the redirector computer by the Eicon software. Microsoft MS-DOS version 5.0 is installed.

On the server (the computer with the EiconCard):

REM Starting Novell with NetBIOS emulation
IPX
NET5
NETBIOS

REM Starting X.25
NABIOS SRV x25serv mypassword /12
ECLOAD


On the redirector (the X.400 gateway computer):

REM Starting Novell with NetBIOS emulation
IPX
NET5
NETBIOS

REM Starting X.25
NABIOS RDR x25redir /4
ECUSE x25serv mypassword



Additional query words: 3.20 PC

Keywords: KB104067