The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

Knowledge Base

Adding SCSI Controllers to Onboard SCSI

Article ID: 103625

Article Last Modified on 11/1/2006

APPLIES TO

Microsoft Windows NT Advanced Server 3.1
Microsoft Windows NT Workstation 3.1
Microsoft Windows NT Advanced Server 3.1

This article was previously published under Q103625

SYMPTOMS

When adding SCSI controllers to a computer that already contains an onboard SCSI controller, you may receive the following error message:

Windows NT could not start because of a computer disk hardware configuration problem.
Could not read from the selected boot disk. Check boot path and boot hardware.

Please check the Windows NT documentation about hardware disk configuration and your hardware reference manuals for additional information.

Boot failed.

CAUSE

This error may be caused when additional SCSI adapters are installed on computers that contain an onboard SCSI controller. This can change the device ID of the onboard controller, causing Windows NT not to boot.

RESOLUTION

Editing the BOOT.INI file to change the SCSI() and /SCSIORDINAL: parameters corrects this problem.

MORE INFORMATION

To edit the BOOT.INI file to correct the above problem, do the following:

Remove the attributes from the BOOT.INI file with the ATTRIB command:

      ATTRIB -R -S -H BOOT.INI

Use Notepad to edit the BOOT.INI file.

Change the following lines in the BOOT.INI

      [boot loader]
      default=scsi(0)...

to

      default=scsi(z)...

and

      [operating system]
      scsi(0)...

to

      scsi(z)...

and

      SCSIORDINAL:0

to

      SCSIORDINAL:z

where z = the new ID of the onboard SCSI controller.

Save the BOOT.INI file.

Restore the attributes to the BOOT.INI file with the following command:

      ATTRIB +R +S +H BOOT.INI

Additional query words: prodnt

Keywords: kbhardware KB103625

Microsoft KB Archive/103625

Contents