Microsoft KB Archive/103549

Knowledge Base

DoubleSpace Err Msg: The Drive Letter <X> Is Not Available...

Article ID: 103549

Article Last Modified on 11/22/1999

---

APPLIES TO

• Microsoft MS-DOS 6.2 Standard Edition
• Microsoft MS-DOS 6.22 Standard Edition

---

This article was previously published under Q103549

SUMMARY

This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames.

SYMPTOMS

When you use the DBLSPACE /HOST command to change your DoubleSpace host drive letter, you may receive the following message

The drive letter <X> is not available for DoubleSpace's use.

where <X> is the drive letter you specified.

CAUSE

You receive the previous message when:

• The letter you specify for the new host drive is in use by an existing physical drive or DoubleSpace drive. -or-
  

• The drive letter you specified is greater than the LastDrive= entry in the DBLSPACE.INI file.

RESOLUTION

To determine which drives are currently in use on your system, type dblspace /list at the MS-DOS command prompt, and then press ENTER.

To specify a drive letter greater than the LastDrive= entry in the DBLSPACE.INI file:

1. Use the DBLSPACE /LASTDRIVE command to increase LastDrive= entry in the DBLSPACE.INI file. For example, type dblspace /lastdrive=j at the MS-DOS command prompt and then press ENTER.
2. Restart your computer.
3. Use the DBLSPACE /HOST command to change your DoubleSpace host drive letter. For example, if your DoubleSpace-compressed drive is drive C and you want to change your host drive to drive I, type the following at the MS-DOS command prompt and then press ENTER:

   dblspace c: /host=i:

4. Restart your computer.

Additional query words: 6.20

Keywords: KB103549

---

Send feedback to Microsoft

© Microsoft Corporation. All rights reserved.