Article ID: 101679
Article Last Modified on 10/30/2006
APPLIES TO
- Microsoft Mail Gateway to X.400 3.2
This article was previously published under Q101679
SYMPTOMS
This network error format may appear when an EiconCard error occurs:
Here is an example of an EiconCard error message:
MORE INFORMATION
The following table lists the messages, along with their error numbers, that may be displayed:
Message Error Number -------------------------------------------------------------------- Invalid buffer length. 1 Invalid command. 3 Command time-out. 5 No circuit available. 9 Call cleared. 10 Command canceled. 11 PU name exist. 13 PU name table full. 14 Session table full. 17 Unsuccessful call. 18 Protocol name not found. 20 Circuit in use. 22 PU name not found. 23 Session reset. 14 Trace not started. 25 Insufficient memory. 26 Too many outstanding commands. 34 Bad port number. 35 No number to dial. 37 No dial tone. 64 Modem test failed. 80 Modem not ready. 144 Modem not ready (no DSR). 145 Modem not ready (no CTS). 146 Modem not ready (no clock). 147 Remote line busy . 148 Remote not answering. 149 No line available. 150 Modem in use. 153 Bad phone number syntax. 158 Modem initialized. 159 Link level not ready. 160 Packet level not ready. 176 Restart indication received. 178 Transport connection cleared remotely. 192 Transport connection cleared locally. 193 Time-out occurred on CR or DR. 194 X.25 network connection cleared. 195 X.25 network reset. 196 Transport connection refused by remote. 197 CR sent by remote site not acceptable. 198 Not enough memory to start transport layer. 207 Submit request again. 248 EiconCard snapshot. 249 EiconCard snarked. 250 EiconCard error. 251 EiconCard not loaded. 252 EiconCard halted. 253 EiconCard driver not installed. 254 Command not completed. 255
Additional query words: 3.20 errmsg alert eicon card
Keywords: KB101679