Article ID: 100984
Article Last Modified on 11/23/1999
APPLIES TO
- Microsoft MS-DOS 6.0 Standard Edition
- Microsoft MS-DOS 6.2 Standard Edition
- Microsoft MS-DOS 6.21 Standard Edition
- Microsoft MS-DOS 6.22 Standard Edition
This article was previously published under Q100984
SUMMARY
This article describes two features of the clean start and interactive start function keys (F5 and F8, respectively) that are not documented in the "User's Guide." Because these features were added late in the product development cycle, this information does not appear in the "User's Guide."
MORE INFORMATION
As documented under "Bypassing CONFIG.SYS and AUTOEXEC.BAT Commands" on pages 103-104 of the "User's Guide," you can use the F5 key to completely bypass your CONFIG.SYS and AUTOEXEC.BAT commands, or you can use the F8 key to confirm each CONFIG.SYS command. You can also press and hold down the SHIFT key when MS-DOS displays the "Starting MS-DOS..." prompt to completely bypass your CONFIG.SYS and AUTOEXEC.BAT commands.
Note: If you hold down the SHIFT key, you do NOT receive the following standard message displayed when you press F5:
New Information
Once you have started selectively processing your CONFIG.SYS commands by pressing F8 (or CTRL+F8 in MS-DOS 6.2), you can respond "Yes" to all remaining prompts, including "Process AUTOEXEC.BAT [Y/N]?," by pressing ESC. Or, you can respond No to all remaining prompts, including "Process AUTOEXEC.BAT [Y/N]?," by pressing F5.
Additional query words: 6.22 6.00 6.20 escape ctrl+f5 ctrl-f5 ctrl-f8 control
Keywords: KB100984
