Microsoft KB Archive/931035

From BetaArchive Wiki
Knowledge Base


How to enable tracing in Desktop Solutions GPOVault Enterprise 2.0

Article ID: 931035

Article Last Modified on 8/15/2007



APPLIES TO

  • GPOVault Enterprise 2.0



INTRODUCTION

This article describes how to enable tracing in Desktop Solutions GPOVault Enterprise 2.0.

MORE INFORMATION

You can use detailed trace information to help speed up the resolution of problems that might occur in GPOVault Enterprise 2.0. The detailed trace information can be written to the file system. By default, tracing is disabled in GPOVault Enterprise 2.0.

To enable tracing, create a new registry entry under the following registry subkey:

HKEY_LOCAL_MACHINE\Software\DesktopStandard\GPOVault


Use the following information in the new registry entry.

Entry Type Value
TraceLevel REG_DWORD 0 through 4

The meanings of the values are as follows:

  • 0: No tracing
  • 1: Trace errors
  • 2: Trace errors and warnings
  • 3: Trace errors, warnings, and general information
  • 4: Trace all information

After you create the registry entry, you must restart the Group Policy Management Console (GPMC). You must also restart the GPOVault Service in GPOVault Enterprise.

The GPOVault trace file is located in the following location:

%UserProfile%\Local Settings\Application Data\DesktopStandard\GPOVault\Gpovault.log


The GPOVault Enterprise trace file is located in the following location:

%AllUsersProfile%\Application Data\DesktopStandard\GPOVault\Gpovents.log


Keywords: kbhowto kbexpertiseinter KB931035