Microsoft KB Archive/57888

From BetaArchive Wiki
Knowledge Base


You have to make two calls to the getch()function when you read extended characters

Article ID: 57888

Article Last Modified on 4/28/2005



APPLIES TO

  • The C Run-Time (CRT), when used with:
    • Microsoft Visual C++ 1.0 Professional Edition
    • Microsoft Visual C++ 1.5 Professional Edition
    • Microsoft Visual C++ 1.0 Professional Edition
    • Microsoft Visual C++ 2.0 Professional Edition
    • Microsoft Visual C++ 2.1
    • Microsoft Visual C++ 4.0 Standard Edition
    • Microsoft Visual C++ 5.0 Standard Edition
    • Microsoft Visual C++ 6.0 Service Pack 5



This article was previously published under Q57888


SUMMARY

In Microsoft C, when reading extended characters you must make two calls to getch() because the first call returns a value indicating that the key is an extended character. The second call returns the actual key code. When you are reading an extended character, the first return value will be either 0xE0 or 0x00, depending on which extended key is pressed.

Sample Code

#include <stdio.h>
#include <conio.h>

void main(void)
{
    int ch, scan;

    do {
        ch = getch();    /* 1st getch() gets ASCII code */ 
        printf("Character is %d\n", ch);
           if (ch == 0x00 || ch == 0XE0)  { /* if extended key */ 
            scan = getch();  /* 2nd getch() gets "scan code" */ 
            printf("\tExtended character:  scan is %d\n", scan);
        }
    }  while (ch != 27);    /* exit loop on ESC */ 
}

For a discussion of keystrokes and scan codes, refer to "The New Peter Norton Programmer's Guide to the IBM PC & PS/2," by Peter Norton and Richard Wilton.

Keywords: kbinfo kbcode KB57888