Microsoft KB Archive/255926

From BetaArchive Wiki
Knowledge Base


Outlook Express Starts Remote Access When HTML Message Is Selected

Article ID: 255926

Article Last Modified on 10/2/2002



APPLIES TO

  • Microsoft Outlook Express 5.0 Macintosh Edition



This article was previously published under Q255926

For information about the differences between Microsoft Outlook Express and Microsoft Outlook e-mail clients, click the following article number to view the article in the Microsoft Knowledge Base:

257824 OL2000: Differences Between Outlook and Outlook Express


SYMPTOMS

After you download messages in Outlook Express and disconnect, if you select a message containing HTML (in any folder), Outlook Express may start Apple Remote Access again, which establishes a connection, and then stops the computer. When this occurs, you must manually restart the computer.

CAUSE

This behavior can occur if an Outlook Express schedule is set to disconnect after sending and receiving messages and the Remote Access Connect automatically when starting TCP/IP applications option is enabled. When you select an HTML message, the software presumes that a TCP/IP connection is necessary and tries to establish a connection.

WORKAROUND

Use the following steps to disable the automatic connection option in Remote Access:

  1. On the Apple menu, point to Control Panels, and then click Remote Access.
  2. Click Options.
  3. Click to clear the Connect automatically when starting TCP/IP applications check box.
  4. Click OK, close the Remote Access window, and then click Save to save the changes.


MORE INFORMATION

A live Internet connection is not necessary to view e-mail messages that contain HTML content; disabling the automatic connection option in Remote Access prevents the selection of HTML messages in Outlook Express from invoking the dialer. Send/receive schedules continue to automatically invoke the dial-up process when they are run. However, with the automatic connection option disabled in Remote Access, starting Microsoft Internet Explorer does not automatically start the dialer. You must start Remote Access manually before browsing the Internet.

Keywords: kbenv kbprb kb3rdparty KB255926