Microsoft KB Archive/251432

From BetaArchive Wiki
Knowledge Base

ISA Network Adapter Does Not Work After Suspend and Resume

Article ID: 251432

Article Last Modified on 1/27/2007


  • Microsoft Windows 98 Second Edition

This article was previously published under Q251432


When you are using an Industry Standard Architecture (ISA) network adapter in an IBM SelectaDock III docking station, network resources may be unavailable after you place the computer in Standby mode (by clicking Start, clicking Shut Down, and then clicking Stand By), and then resume the computer (or wake it up).

When this occurs, Device Manager may display an exclamation point (!) in a yellow circle and a status of "Code 10" for the network adapter.

This problem has been reproduced with the following network adapter:

  • IBM 10Base-T WOL Etherjet ISA adapter

This problem does not occur with peripheral component interconnect (PCI) adapters.


To work around this problem, restart your computer.

Keywords: kbhardware kbnetwork kbprb KB251432