Microsoft KB Archive/247685

From BetaArchive Wiki
Knowledge Base


PSS ID Number: 247685

Article Last Modified on 11/13/2003



The information in this article applies to:

  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • Microsoft Windows 2000 Datacenter Server



This article was previously published under Q247685

SYMPTOMS

When you are using a multihomed Remote Installation service (RIS) server, Pre-boot Execution Environment (PXE) clients may not receive an answer from the server. The clients may display a message similar to:

DHCP..........
No reply from a server.
Press any key to reboot system.

When you check the Application event log, there are no error messages from the Boot Information Negotiation Layer service (Binlsvc). The event log also indicates that the server is authorized in Active Directory and can service clients. The multihomed system is also running the Dynamic Host Configuration Protocol (DHCP) service with active, enabled scopes for each network adapter.

Note that using RIS on a multihomed system requires that you also run the DHCP service, and each network adapter must have an active and enabled scope. If not, PXE clients are not answered by the server.

CAUSE

When the RIS server was authorized by using the DHCP snap-in, the name of the server was entered instead of the IP address of each enabled network adapter in the system. The name that was provided in the Authorization dialog box maps back to an IP address, so only one network adapter ends up being authorized.

RESOLUTION

When you authorize the server by using the DHCP snap-in, type the IP address of each network adapter in the system instead of using the server name. For example, if your system has three network adapters, you must authorize each network adapter, almost as if you were authorizing three different servers.

MORE INFORMATION

For additional information, click the article number below to view the article in the Microsoft Knowledge Base:

260521 Multi-Homed RIS Server May Not Answer All PXE Clients




A multihomed computer can be a machine with multiple network cards installed or multiple IP addresses bound to a single card.

Keywords: kbenv kberrmsg kbprb KB247685
Technology: kbwin2000AdvServ kbwin2000AdvServSearch kbwin2000DataServ kbwin2000DataServSearch kbwin2000Search kbwin2000Serv kbwin2000ServSearch kbWinAdvServSearch kbWinDataServSearch