Microsoft KB Archive/169520

From BetaArchive Wiki
Knowledge Base


XFOR: Installing the the Proxy Address Generator for the Linkage Exchange-OV/VM Connector

Article ID: 169520

Article Last Modified on 10/28/2006



APPLIES TO

  • Microsoft Exchange Server 5.0 Standard Edition



This article was previously published under Q169520

SUMMARY

In a multiple-site environment, sites other than the site where LinkAge Message Exchange is installed need the proxy generator and the address template to send and receive mail with the connected systems.

The following instructions identify the steps necessary to install the proxy generator and the address template for the LinkAge Exchange-OV/VM Connector on a site separate from the site where the connector is installed.

  1. The following files are required for these steps, and can be obtained from the C:\Linkage\Install directory on the currently installed LinkAge connector:

    • Mexitmpl.exe
    • Exiaddr.exe
    • Ibmpxgen.dll
    • Ibmscr.blt
    • Ibmadt.blt
    • Ibmadt.hlp
  2. Create a C:\Linkage\Install directory on the Exchange Server computer in the site where the proxy generator and the address template are to be installed, and copy the above files to this directory.
  3. Create the following directory where the PROFS proxy address generator will exist:

          \\MEXServerName\Address\PROFS\I386
                            
  4. Copy the following file into the directory created in step 3:

    Ibmpxgen.dll

  5. Run the following command from the C:\Linkage\Install directory to install the PROFS address template on the Exchange Server computer:

          mexitmpl "/org=MEXOrganization" "/site=MEXSite"
          "/Server=MEXServerName" /ADDRTYPE=PROFS
          /SYNTAX=c:\linkage\install\ibmscr.blt
          /ADDRESS_DT=c:\linkage\install\ibmadt.blt
          /LANGUAGE=409 /FILE=c:\linkage\install\ibmadt.hlp
          /DATA16=c:\linkage\install\ibmadt.hlp
          /DATA32=c:\linkage\install\ibmadt.hlp /SF
                            
  6. Check the following files to see if any errors occurred with the above command:

    • Lmeistat.txt
    • Lmeilog.txt
  7. Run the following command from the C:\Linkage\Install directory to install the proxy address rule and to optionally generate proxy addresses:

          mexiaddr "/org=MEXOrganization" "/site=MEXSite"
          /Server=MEXServerName"  /ADDRTYPE=PROFS
          /MACHINE=I386 "/PROXYRULE=PROFS:nodeid(&m)"
          /PROXYDLL=c:\linkage\install\ibmpxgen.dll  /SF
                            

    Replace nodeid with the node ID assigned to the connector.

    If proxy addresses are NOT to be generated, then insert /NOGENADDR before the /SF

  8. Check the following file to see if any errors occurred with the above command:

    • Lmeistat.txt
    • Lmeilog.txt


Keywords: KB169520