Microsoft KB Archive/104604

From BetaArchive Wiki

Article ID: 104604

Article Last Modified on 11/1/2006



APPLIES TO

  • Microsoft Windows NT Advanced Server 3.1
  • Microsoft Windows NT Workstation 3.1
  • Microsoft Windows NT Advanced Server 3.1



This article was previously published under Q104604

Windows NT does not provide drivers for the Columbia Data Products SST WD7000-FAAST and WD7000-FAAST2 ultra high-speed SCSI controller cards. However, Columbia Data has made available an upgraded BIOS called SST IV version 1.0 which has support for Windows NT and OS/2 2.x. This is an $85.00 upgrade and is only available through Columbia Data Products.

If the BIOS on the card is 3.36 or greater, another alternative is to use the beta driver available for these cards found on Columbia Data's technical support BBS.

The Columbia Data Products products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability, nor does Microsoft support any of these drivers or cards at this time.

Columbia Data Products can be reached at the following:

   Columbia Data Products, Inc.
   1070B Ranier Dr.
   Altamonte Springs, FL 32714-2584
        



   Technical Support      (407)869-6700  10:00 A.M. - 6:00 P.M. EST, M-F
   Technical Support BBS  (407)862-4724
   Fax                    (407)862-4725
        




Features of the 7000FAST2 Card

  • Supports up to seven devices on a single controller card--up to fourteen on two controllers
  • Intelligent Z-80 CPU channel control
  • Built-in floppy controller
  • WD33C93A SBIC for SCSI interface
  • First-party high-speed bus-mastering DMA data transfers
  • Up to 16-megabyte (MB) block-size transfers
  • 16-byte FIFO on AT bus for sustained data rate performance
  • Up to 4.0 MB per second SCSI synchronous data transfer rate
  • Up to 2.0 MB per second SCSI asynchronous data transfer rate
  • Up to 5.3 MB per second host transfer rate
  • Bus arbitration including disconnect and reconnect
  • Standard and extended SCSI commands
  • Supports full SCSI command set (SCSI I & II)
  • Single +5V power supply
  • On-board controller diagnostics
  • AT card form factor
  • Supports up to 64 logical devices
  • Linked SCSI commands


Host Interface

  • 16 bit, bidirectional AT bus
  • 62-pin card edge connector
  • 38-pin card edge connector


SCSI Interface

  • 9-bit, bidirectional SCSI bus
  • 50-pin SCSI controller
  • Internal -50 pin header
  • External -50 pin D style
  • 20 foot maximum (6 meters) drive cable


Default Addressing



DRQ Address      -   6
DACK Address     -   6
IRQ Address      -  15
I/O Port Address - 350h
IOS ROM Address - Variable (C800h - DC00h)
        


Additional query words: prodnt FAST

Keywords: kbhardware KB104604