Registrations are now open. Join us today!
There is still a lot of work to do on the wiki yet! More information about editing can be found here.
Already have an account?

Microsoft KB Archive/103561

From BetaArchive Wiki
Knowledge Base


Clean Start: DblSpace Maintenance Program Runs in Setup Mode

Article ID: 103561

Article Last Modified on 11/18/1999



APPLIES TO

  • Microsoft MS-DOS 6.2 Standard Edition
  • Microsoft MS-DOS 6.22 Standard Edition



This article was previously published under Q103561

SUMMARY

If you bypass loading DoubleSpace by pressing CTRL+F5 or CTRL+F8 at the "Starting MS-DOS..." prompt, the DBLSPACE.BIN file is not loaded.

If you run DBLSPACE.EXE on any uncompressed drive, it operates as if you never installed DoubleSpace and therefore enters DoubleSpace Setup. Although this doesn't cause any harm or data loss, it can be confusing.

To run the DoubleSpace maintenance program (DBLSPACE.EXE) and change your DoubleSpace configuration, restart your computer and then run the DoubleSpace maintenance program.

NOTE: This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames.


Additional query words: 6.20

Keywords: KB103561