Problem installing Memphis 1511

Post by **vlad557776** » Mon Sep 09, 2019 7:02 pm

Hello.

Recently I was installing Memphis 1511 on PCem, but, when I start Setup, it normally runs ScanDisk, but after, it says: "WINSETUP caused a General Protection Fault in module USER.EXE at 000C:1878.". After I click "Close" it goes back to my 98SE command prompt saying "Standard Mode: Invalid DPMI return from 06F7:01B2"

Please help!

Post by **TheCollector1988** » Mon Sep 09, 2019 7:07 pm

It's because of a limit check missing on PCem's source code, this bug is not present anymore on 86box (in the internal builds only, not committed yet).
Edit: Added the fact it's not committed yet.

Post by **tarquin44** » Mon Sep 09, 2019 8:35 pm

You can also overcome this problem in PCem by switching WINSETUP.BIN from an earlier build, the one from build 1488 works.

Post by **TheCollector1988** » Mon Sep 09, 2019 9:24 pm

Yeah, but it would just look weird.

Post by **vlad557776** » Sat Sep 14, 2019 7:57 am

Fixed by using WINSETUP.BIN from 1488. But I needed to press "Skip File" a few times because it wanted some AOL files, which my ISO didn't have.

Problem installing Memphis 1511

Problem installing Memphis 1511

Re: Problem installing Memphis 1511

Re: Problem installing Memphis 1511

Re: Problem installing Memphis 1511

Re: Problem installing Memphis 1511